Adaptive Technologies PM-24-6UP-G - Manual

© 2011 Allen Products Company, Signal Hill, CA 90755 USA (562) 424-1100 REV00-020111
PoleStar ™ PM-24-6UP-G
6” & Up Pole Mount with 24” long Arm
Installation Instructions
The PoleStar ™ PM-24-6UP-G all-weather, galvanized steel pole
mount is designed to mount loudspeakers and other equipment
from vertical surfaces and columns. The PoleStar
™ PM-24-6UP-G
accommodates many standard mounts for a wide variety of
mounting solutions, including, yokes, U-Brackets and the
PoleStar
™ dual Adapter for mounting and aiming three
loudspeakers.
The universal strap kit provides a banding system to attach the PM-
24-6UP-G Pole Mount to vertical poles or columns from 6” diameter
and up.
Important: Mounting overhead system requires professional
experience. Improperly installed equipment can result in
property damage, personal injury, death and/or liability to the
installing contractor. Do not install if in doubt about the integrity of
the mounting structure.
Caution: Due to the wide variety of mounting structures,
environments, materials and mounting methods, the installing
contractor must exercise good judgment in selecting the proper
mounting area and hardware.
Follow these instructions for the most efficient and safest
mounting results.
Do not exceed the working load limit of 300lbs/136 kg.
DO NOT use Pneumatic tool to tighten bolts.
Use Loctite to permanently secure nuts to bolts and prevent
loosening overtime.
Bolt Torque: 35-40 foot pounds
Package Contents:
1 pc.
Pole Mount, 6” & Up w/ 24” arm 1 pc Friction gasket
1 pc ½-13 x 3.5 hex bolt
1 pc ½-13 x 4.5 hex bolt
1 pc ½-13 nylock nut
1 pc ½ split lock washer
1 pc ½ Flat washer
2 pcs 90” long banding strap
2 pcs Retaining bolt & block assy.
2 pcs Flat washer, 3/8 SAE
1 pc Loctite #262
1 pc Instruction sheet
Install Banding Strap Kit:
Step 1: Assemble Fixed Retainer Block from the Band Kit
Mark the strap at least 4-6 inches from the end and fold the strap at the mark. Strike the strap at the bend to create a sharp radius. Slide the strap
through the Fixed Retainer Block so that its bend will pass over the beveled end of the Block. (Figure 1)