Adaptive Technologies SAS-100-CM - Manual

© 2004 Allen Products Company Incorporated, Signal Hill, CA 90755 USA (562) 424-1100 07/04
Figure 2
SAS-100-CM Ceiling Mount
Adjustable Tilt Cable Application
Installation Instructions
Thank you for selecting the SAS-100-CM Steerable Speaker Ceiling Mount. This
universal ceiling speaker mount provides a 360° pan angle adjustment. It suspends
and precisely aims speakers equipped with rigging points from ceilings and other
structural overhead surfaces.
Important:
Mounting and rigging video equipment requires experienced professionals.
Improperly installed video equipment can result in property damage,
personal injury, death and/or liability to the installing contractor. Do not
install if in doubt about the integrity of the mounting structure.
Caution:
Due to the wide variety of building structures, materials and mounting methods, these
instructions assume that the installing the contractor/installer will exercise good
judgment in selecting proper mounting area and hardware.
As a guide, the installation, when completed should be capable of supporting at least 5
times the actual applied load.
Follow these instructions for the most efficient and safest mounting results.
Step 1. Install Ceiling Plate:
Secure the ceiling plate above a structurally sound horizontal grid. Be sure the ceiling plate
center is level and directly above your desired suspension point (Figure 1). If you have
doubts about the integrity of the structure you are mounting to, or you are not sure about
the proper hardware to use, consult your local hardware specialist.
Step 2. Install Extension Coupler:
Thread the extension coupling into the threaded hub of the ceiling plate, then place the
wire mesh cover around it(Figure 1).
Step 3. Assemble the Cross Arm:
Permanently attach the eyebolts to the cross bar with flat washers and Nylock nuts then the end
caps (Figure 2).
Step 4. Assemble the Center
Hub:
Assemble the hub to the cross arm
using the hex bolt, washers, Teflon
washer and Nylock nut. Insert the
cotter pin into the hole of the 1/2”
bolt then fold the end to secure
(Figure 3).
Step 5. Install Cross Arm to
Ceiling Plate:
Align and hand thread the hubcap
of the cross arm assembly over the
extension coupling inside the ceiling plate. Use a pipe wrench to tighten connection permanently (Figure 4). Slip mesh
evenly over both hubs.
Figure 1
Figure 3