Adaptive Technologies TCK-022-S - Manual (Page 4)

 Allen Products Co., Inc. Signal Hill, CA 90755 (562) 424-1100 0503
Figure 7: Pulley and Fixed Cable assembly
Step 1. Attach Tilt / Pull-Back Cable
Connect the pullback cable to the top front anchor points of the speaker (such as eyebolts or track fittings, etc) as
shown in the above drawing. Using the pulley’s shackle, secure one end of both fixed cables to the pulley (Figure 7).
Step 2. Attach Rear Fixed Cables
Attach each end of the second set of fixed cables to the back anchor points of the speaker with the supplied
shackles as shown in the above drawing.
Step 3. Attach Fixed Cable to Main Suspension Point
Connect the front left and the rear left fixed cables to the left suspension point (of your chosen rigging or mounting equipment) using the supplied shackle (Figure 4).
Repeat step for the right front and right rear fixed cables.
Step 4. Adjust Speaker’s Tilt Angle
To decrease the tilt angle of the speaker, compress the knurled end of the clutch lock then pull the pull back cable away from the pulley until the desired angle is
achieved. (Figure 9) To increase the tilt angle of the speaker, support the weight of the speaker then compress the knurled end of the clutch lock and slowly lower the
speaker until the desired angle is achieved. Release the knurled end to lock in place then tighten (Figure 9). Coil the extra cable or trim and place a stop swage on the
end.
Step 5. Secure Shackles and Clutch Lock
To prevent the screw pin of the shackles from loosening over time, secure them using a tie wrap as shown in figure 8. Tape the knurled end of the clutch lock to avoid
long term loosening.
Figure 8: Securing the shackles
Four-Point Configuration
Figure 9: Clutch Lock tilting mechanism