AvaLAN Wireless AW58300HTS - Manual (Page 11)

AW58300HTA, HTS User’s Manual
PAGE 11 Technical Support (650) 384-0000 www.avalanwireless.com
A. Connect the opposite end of your Ethernet cable to
the Power over Ethernet Injector, and the RJ45 tail of
the PoE to your network.
B. Connect the PoE to your 18 VDC Power Supply and
it to a standard 120 VAC outlet.
Troubleshooting:
Power:
- Check that the POE cabling matches illustration
- Check network connection on your switch and verify all RJ45 cables are plugged in properly
- Only use the POE injector supplied
- Ensure the 110VAC is providing clean and consistent AC power to the 18VDC power supply
Signal Quality:
- Ensure line of sight (LOS)
- Check signal strength in web interface (-40dB is excellent strength and –80dB is weak)
Web Interface:
- Plug RJ45 male side of POE directly in to computer and verify network status shows connected
- Verify the local computer’s network settings are in the same IP subnet range as the radio