Aviom Pro64 - Manual (Page 2)

Additional Information
Connecting devices
Aviom, A‑Net, the A‑Net icon, Pro16, Pro64, and Virtual Data Cable are trademarks of Aviom, Inc. All other trademarks are the property of their
respective owners. ©2009 Aviom, Inc. All rights reserved. Information subject to change without notice. P/N 9311 1025 0001F rev. 1.0 111109
On the Clock Master, • * press the Sample Rate button until the
desired sample rate is indicated by the LED. Press ENTER.
* In most cases the Clock Master will also be the Control Master. Only a 6416dio
can be set as the Clock Master without also being the Control Master.
Activate inputs as desired. •
In Auto Mode, • * the A and B ports can be used interchangeably.
* To select Auto Mode, use the A-Net Transmit or A-Net Receive button on the
front panel of the Control Master. This will set all devices to Auto Mode.
In Auto Mode, ports 1-10 on MH10 and MH10f Merger Hubs are •
all bidirectional and interchangeable.
Use unshielded Cat-5e or better (UTP). Max length 400ft/120m.
•
Using fiber optics
Ports 9 and 10 on the MH10f Merger Hub can be loaded with •
single- or multi-mode SFP transceivers.
Aviom-tested transceivers include:
•
LAN Basics OT-2001 (multi)
Avago HFBR 57E0PZ (multi)
Finisar FTLF 1217P2BTL (multi) LAN Basics SFP-3103 (single)
Planet MGB-LX (single)
Configuring mic pre remote control with the MCS
Connect an MCS to an RCI anywhere in the network •
(in Auto Mode).
Make sure that both the RCI and all 6416m modules to be
•
controlled are set to the same Control Group.
Individual channels must be active in the network to be
•
controlled remotely.
Using an external clock (other than a Yamaha console)
Connect the external clock to a 6416dio (Word Clock or AES3 in). •
Make that 6416dio the Clock Master with the front panel •
button. Press ENTER to confirm. Alternatively, make that
6416dio the Control Master with the rear panel DIP switch.
Select the Clock Source with the front panel button. Press
•
ENTER to confirm.
Set the Clock Source on all other 6416dio modules to “Network.”
•
Using a Yamaha console as the clock source
Set • one 6416Y2 in the console as the Control Master. Make sure
the Clock Source on all 6416dio modules is set to “Network.”
Refer to the 6416Y2 User Guide or Reference Card for more
•
detail and complete set-up instructions for the 6416Y2.
Changing the sample rate
www.Aviom.com