Bio Bidet BLISS Premier Class Bidet Seat - Manual (Page 7)

PREPARATION 2
SIT DOWN ON THE SEAT
When you sit down on the seat, the ORANGE LED lamp on the control panel will light up.
When the digital sensor on the seat is activated, the operation LED window on the main unit
will light “Occupied sensor” and simultaneously, the deodorizer fan will start to work.
(BB-1700 / BB-2000 Models)
See page 14 for details about changing the seat or water temperature.
Please plug the power cord into AC110V power outlet.
Plug the unit into the proper power source and the LED power light will start flashing.
Wait until the LED power light stops flashing and becomes solid red.
The water tank will be filled after pushing a “Wash”( or , or ) button.
When the water tank is filling the buzzer “Beeps” continuously.
After the water tank is full the buzzer will end with “One Solid Beep”.
Check for any water leaks. 1
Please turn on the water supply valve and check connected spots(1~5) for the leakage.
OPERATION 3
CLEANSING
CLEANSING 1. (Posterior Wash)
1- Press “Posterior Wash”( , ). Automatically, the nozzle comes out and
sprays warm water to posterior.
2- Additional functions during your Posterior Wash experience are available. See Oscillation,
page 15 and Massage, page 16 for details.
STOP
Press this button to stop all operation.
CLEANSING 2. (Feminine Wash)
1- Press “Feminine Wash”( , ). Automatically, the nozzle comes out and
sprays warm water to feminine area.
2- Additional functions during your Feminine Wash experience are available. See Oscillation,
page 15 and Massage, page 16 for details.
CLEANSING 3. (Turbo Wash / Vortex Wash)
1- Press “Turbo Wash” ( ) or “Vortex Wash” ( ), the nozzle spray is more or
focused to produce the effect of strong wash, to help stimulate bowel movement.
2- Press “Water pressure - High & Low button” to adjust the water pressure.
CLEANSING cont.
CLEANSING 3. (Turbo Wash or Vortex Wash)
1- Press “Turbo Wash” or “Vortex Wash” continuously for 3 to 5 seconds. Automatically, the water
nozzle comes out and sprays a warm stream of water to the posterior center of the rectum.
2- If necessary, adjust “Position” of water stream with the ( / )buttons.
3- Press “Water pressure High & Low button”( / )to adjust the water pressure
to your desired comfort.
4- Press the “STOP”( )button when you feel your abdomen is full or wait until
the “Turbo Wash” or “Vortex Wash” function stops, approximately 1 minute.
5- You will shortly feel the urge to push the water out of your colon, push the water and feces
out as thoroughly as you can.
6- Relax for a few minutes and be sure you feel your colon is empty and then use
the “Posterior Wash” and “Air Dry” function to finish.
Installation Manual and Operating Instructions 12 13
4 Operation (Basic)
CAUTION
Please press the “off” or “low” button to reduce the seat temperature after using.
Special precautions should be taken for children, those who cannot adjust the temperature,
and those who have sensitive skin.
CAUTION
OPERA
TION
CAUTION
DO NOT ALLOW CHILDREN TO USE THE TURBO WASH or VORTEX WASH FUNCTION!
SUPERVISION IS STRONGLY RECOMMENDED FOR THE ELDERLY OR OTHER PERSONS
THAT MAY HAVE LIMITATIONS IN BODY MOVEMENT, ILLNESS OR DISABILITIES!
Observe at all times
water supply
vavle