Bio Bidet Harmony Luxury Class Bidet Seat BB-400 - Manual (Page 5)

9 Installation Manual and Operating Instructions
Check the water valve in the bathroom. You may need to consider purchasing additional components.
For the following case, the T-valve alone is sufficient for connection.
Minus home Handle Inner bolt for water valve
Water supply valve Inner bolt water valve
Please consult with a qualified specialist.
Please put the unused water hose in a secure area.
Professional engineering is needed for plumbing work
on specialized water pipes and flush valve pipes.
This product requires 120V usage.
Please do not plug in the electrical cord prior to installation.
Please consult with a licensed electrician if electrical work is needed, and in case a grounded outlet
is not available, grounding should be done in order to prevent short circuits or electric shock.
Caution
Shut water supply by turning it to the
right and disassemble the water hose.
Water supply hose
Water valve
Remove existing seat and lid.
Release the bolts on both
sides of the existing toilet
seat to remove the seat
and lid.
Store the removed seat,
nut and water hose in a
safe area in case you
move or it needs to be
reinstalled.
Connect the water supply hose to the
T-valve. Insert the packing in the T-valve. Connect the water supply hose to the assembled
T-valve.
Conversion Nut
(with packing)
T-valve
(with packing)
If the water supply hose is old or
damaged please replace it with the water
supply hose that is included with the unit.
If the water supply valve opening is 1/2 inch please use
a conversion nut to connect it with the T-valve.
T-valve packing must be used to prevent water from leaking.
Nut Toilet
body
Exisiting toilet seat
Once the base plate is attached to the unit,
align the unit and toilet fixture facing front,
and then insert the mounting bolts
to the toilet mounting holes.
Put the bolt into the bolt case and align it
with the top of the base plate. Insert bolt
with bolt case onto the base plate. After this
is done hold the bolts, slide it into the
bottom of the unit until it snaps in place. Install the main unit and insert the
mounting bolts to the toilet mounting
holes.
Connect the flexible tube from side of
T-valve to the unit. Turn the water
valve to the left to allow water to flow.
Installed bolt case
Bolt
Bolt
Back
Base plate
Cone Packing
Nut
Water supply valve
Water supply hose for electronic
toilet seat
Check the water valve
Installation steps
Cone Packing
Nut
8 Installation Manual and Operating Instructions
3 Installation
INST
ALLA
TION