Buzz Audio ma-2.2stereo microphone preamp - Manual (Page 3)

2
1] The Mains Input.
As a safety precaution your MA 2.2 is shipped without a
mains fuse fitted. Before use, you must select the
correct mains voltage for your local supply on the rear
panel and fit the correct mains fuse type into the fuse
draw for that voltage.
• Setting the Voltage Selector…
You will need a flat blade screwdriver.
If your mains voltage is 110V to 120V set the rear panel voltage
selector to 120V.
If your mains voltage is 220V to 240V set the rear panel voltage
selector to 240V.
POWERING UP THE MA 2.2 WITH THE WRONG VOLTAGE
SETTING MAY CAUSE SEVERE INTERNAL DAMAGE !!
• Selecting the Correct Fuse…
In the supplied accessories bag you will find;
2x 1 Amp slow blow fuses, FIT for 220V to 240V.
2x 2 Amp slow blow fuses, FIT for 110V to 120V.
Slide out the fuse draw above the IEC power inlet and insert the
appropriate fuse into the carrier clip. Note there is also a position in
the carrier for a spare fuse (the square tube bit) and we suggest you
store the second supplied appropriate fuse here.
• Please Note…
Fitting the wrong fuse may result in the fuse blowing on power up or
inadequate protection.
Fitting fast blow type fuses may also result in the fuse blowing on
power up.
Your dealer may have already set all this up for you but it pays to
check it before powering up the MA 2.2.
VOLTAGE SELECTOR FUSE DRAW
MA 2.2 USERS MANUAL VERSION-1 PAGE 2