Buzz Audio req-2.2resonance equaliser - Manual (Page 4)

4
Slide out the fuse draw below the IEC power inlet using a small flat blade
screwdriver and insert the appropriate fuse into the carrier clip. Note there
is also a position in the carrier for a spare fuse (the square tube bit) and we
suggest you store the second supplied appropriate fuse here.
Fitting the wrong fuse may result in the fuse blowing on power up or
inadequate protection. Fitting a fast blow type fuse may also result in the
fuse blowing on power up.
3 3 3 3] ] ] ] Audio Audio Audio Audio Connections Connections Connections Connections
All the XLR connectors on the rear of the REQ-2.2 are balanced and wired
as follows;
Pin 1 = Chassis Ground
Pin 2 = Signal Hot (+)
Pin 3 = Signal Cold (-)
The REQ will accept both balanced and unbalanced inputs, however we
do recommend the use of balanced lines where ever possible. The REQ
has a “looping” input, allowing you to daisy chain it with another device. It
also has two output connectors (paralleled) enabling you to feed two
separate devices if desired.
The REQ output will drive both balanced and unbalanced loads due to our
unique BE44 Discrete Class A line driver module. If the load is unbalanced,
the BE44 will automatically detect this and adjust the output level
accordingly. We do recommend however that balanced loads are utilised
where ever possible for best sonic performance.
PLEASE
PLEASE PLEASE PLEASE NOTE NOTE NOTE NOTE: A LONG TERM SHORT CIRCUIT BETWEEN PIN 2 AND PIN 3 OF THE
OUTPUT XLR’S MAY CAUSE DAMAGE TO THE BE44 MODULE.