California Faucets Styletherm 1/ Thermostatic Rough Valve with Dual Integral Volume Controls - Manual

StyleTherm
™
TH52- R
½” Thermostatic Valve with Dual Volume Control Rough
Installation Instructions
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
WARNING: This valve is factory set to deliver water at 100°F; however, it is the installer’s responsibility to verify correct temperature
setting to prevent risk on scalding or other severe injury prior to consumer use. The installer is responsible for adjusting maximum
temperature setting according to Thermostatic Rough and Thermostatic Trim Installation Instructions.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi *†
Recommended Hot Water Supply Temperature: 120 to 140°F ‡
Nominal Flow Rate @ 60 psi: 10 gpm
* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† f water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
0.0
5.0
10.0
15.0
20.0
20 30 40 50 60 70
Pressure (psi)
Fl
ow
R
a
te
(gpm)
Single Flow Combined Flow
I
‡ Follow all applicable local plumbing codes when setting the temperature on the water heater.
Body
Volume
Control
Thread
Protector
Thread
Protector
Thread
Protector
Mudguard
Support
Volume Control
Mudguard
Valve
Mudguard
Mudguard
Screw
Mudguard
Washer
Valve
Mounting Tab
Volume Control
Mudguard
Thread
Protector
Volume
Control
TH52-R_ii_130102.doc Pg 1