California Faucets Roman Tub Set - Manual (Page 2)

NOTE: Hot & cold valves are labeled: cold=blue & hot=red.
-Remove top nut and turn bottom nut with fiber washer down
the valve until it stops.
-Insert valve through hole from below and install top nut
(if applicable), and adjust to proper height, see Fig. 4A
(also refer to "A" dimension).
-Tighten the bottom nut to secure the valve.
-Install trim parts (base ring if applicable), escutcheon and
handle and tighten handle set screws with Allen key provided.
REMINDER: Please retain allen key as handles may
require re-tightening with normal use.
Fig. 4A
Install valve bodies:
Installation Note for series:
# 32, 33, 34, 35, 36, 43, 57, 60, 61, 67, 68 & 69.
The trim to those products do not require a top nut to be installed
on the valve (See Fig. 4A)
The decorative base ring and escutcheon takes the place of the
top nut. (See Fig. 4B). Fig. 4B
Top
Nut
Fiber Washer
Bottom Nut
Valve Body
"A"
Sink/
Countertop
Decorative
Base Ring
Valve
P 2
3
-Install piping (not provided) to connect hot & cold valves to
connector tee (see Fig. 1).
NOTE: The manufacturer recommends these connections be made in hard copper.
Piping:
"A"
DIMENSION
"A" Dimension is
from top of counter/tub
top to tip of stem broach.
3408 2 3/8" 2 3/8"
3508 2 3/8" 2 3/8"
3608 2 3/8" 2 3/8"
3808 2 5/8" 2 5/8"
4008 2 5/8" 2 5/8"
4208 2 5/8" 2 5/8"
4408 2 3/8" 2 3/8"
4608 2 1/2" 2 1/2"
4708 2 1/2" 2 1/2"
4808,X 2 5/16" 2 5/16"
5308 2 1/4" 2 1/4"
5508 2 5/8" 2 5/8"
5708 2" 2"
5808 2 5/8" 2 5/8"
5908 2 5/8" 2 5/8"
6008 2 1/4" 2 1/4"
6108 2 1/4" 2 1/4"
6208 1 1/8" 1 1/8"
6308 3" 3"
6408 2 5/8" 2 5/8"
6508 2" 2"
6608 2" 2"
6708 2 1/4" 2 1/4"
6808 2 3/8" 2 3/8"
6908 2 3/8" 2 3/8"
Series # Handle Diverter
2
3208 2 3/8" 2 3/8"
3308 2 3/8" 2 3/8"
RT_ii_140122
E208 2 11/16" 2 11/16"
5008 2 1/4" 2 1/4"
5108 2 1/2" 2 1/2"
4508 2" 2"