California Faucets Contemporary Floor Mount Tub Filler - Manual

1103-XX_ii_140625 Pg 1
1103-XX, 1203-XX,
1303-XX & 1403-XX
Floor Mount Tub Filler – trim only
Installation Instructions
1
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure:
20 to 70 psi *†
Maximum Flow Rate: 15 gpm
* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALL FLANGES TO FLOOR
 Remove MUDGUARDS (1)
 Using 3/8” hex KEY (2) (not supplied), remove ½”
PLUGS (3) from NIPPLES (4)
 Place FLANGE (5) onto SHANK (6) and loosely
tighten onto NIPPLE (4) using SCREWDRIVER (7)
in slots of SHANK (6)
 Using PENCIL (8) to mark on finished floor screw
hole locations from FLANGE (5)
 Remove FLANGE (5) and SHANK (6)
 Pre-drill holes in finished floor use following drill bit:
o SCREW (only): 5/32”
o ANCHOR: 1/4”
 Insert ANCHOR (9a) (if required) into pre-drilled
holes
 Place FLANGE (5) onto SHANK (6) and loosely
tighten onto NIPPLE (4) using SCREWDRIVER (7)
in slots of SHANK (6)
 Secure FLANGE (5) into place with SCREWS (9)
 Once SCREWS (9) are tightened, securely tighten
SHANK (6) against FLANGE (5)
Important: It is necessary to securely tighten the SHANK (6)
against FLANGE (5) for proper support of the entire Floor Mount
Tub Filler.
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
Drill Size:
SCREW: 5/32”
ANCHOR: 1/4”