California Faucets Roman Tub Sets 73 Series - Manual

#7208
#7308
THROUGH-HOLE
SPOUT: 1-1/4"
VALVE: 1-1/4"
"A" = 3/4"
THROUGH-HOLE
SPOUT: 1-1/4"
VALVE: 1-1/4"
"A" = 1"
SHANK
NUT
WASHER
SPACER
BASE
SPOUT
Fig. 2
NIPPLE
"A" MIN
COLD INLET HOT INLET
IMPORTANT
7208 & 7308
ROMAN TUB SET
INSTALLATION
INSTRUCTIONS
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
NOTE:
-The manufacturer recommends
the use of hard piping (not flex
connections) for all connections.
-It is also recommended that an
access panel be provided for
all Roman Tub installations.
Tel: 714-891-7797
Fax: 714-891-2478
Toll Free: 800-822-8855
www.calfaucets.com
P1
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
RT_7208_ii_101220
1
Install spout (See Fig. 2) :
-Remove NUT, WASHER, & SPACER from SHANK.
-Apply thread sealant to spout inlet NIPPLE.
-Tighten SHANK onto NIPPLE firmly.
-Insert SPOUT through deck/tub hole.
-Place SPACER (if necessary), WASHER, & NUT onto SHANK.
-Align SPOUT and tighten NUT firmly.
-Apply thread sealant to end of SHANK.
Fig. 1
Due to the thin wall tubular design of this spout, please note the following:
Spout is not meant to be used as a support or grab device. Any excessive weight, pulling or grabbing of spout may
cause damage or injury and will void the warranty.
It may be necessary to initially operate at full flow, then reduce the flow to retain the desired “sheet” flow effect at
lower operating water volume.