Viewing/editing setup information – Cannon Instrument miniAV-LT User Manual
Page 16
CANNON
®
miniAV-LT Automatic Viscometer with VISCPRO
®
Instruction & Operation Manual
Version 1.a— May, 2009; CANNON
®
Instrument Company
2139 High Tech Road • State College, PA 16803 • USA
12
Viewing/editing setup information
NOTE
For first-time installation, make certain that the factory-prepared Configu-
ration file has been copied to the Default Data directory ( see page 7)
per instructions.If your instrument has already been configured, you can
use the instructions in this section of the manual to check or, if neces-
sary, change the instrument settings.
1. Click Configure from the VISCPRO
®
menu bar.
2. Select your instrument group and instrument from the list of avail-
able instruments.
3. Select Tray Settings: Tube and Bath from the list of configuration
options. The Tray Settings: Tube and Bath window will appear.
The Tray Settings: Tube and Bath window
The Tray Settings: Tube and Bath window contains setup information
for each tube associated with your instrument. On multiple-tube CAN-
NON instruments, you can click on the tube tabs to see the setup infor-
mation for different tubes.
4. Verify that the tube serial number (Tube S/N) is correct. If it is not,
input the correct serial number in the text box. Each tube should have
a unique serial number!
5. Verify the presence of calibra-
tion values (C and E) for each
bulb. If calibration data is not
available, the default values are
C=1 and E=0.
Sample calibration constants