Cannon Instrument CT-1000 (Contant Temperature Bath) - Manual (Page 7)

5
CANNON ® CT-1000 Constant Temperature Bath Instruction & Operation Manual
Revision 3.1e—June, 2011; CANNON ® Instrument Company
2139 High Tech Road • State College, PA • USA 16803
2
UNPACKING AND ASSEMBLY
This chapter of the manual provides assistance in unpacking and assem-
bling the CT-1000 Constant Temperature Bath. For additional assistance,
consult the instructional video.
Unpacking the CT-1000
The CANNON ® CT-1000 Constant Temperature Bath is shipped in two
boxes:
„
Box 1 contains the glass jar, front glass panel pieces, jar gasket top,
trimpot adjust screwdriver, Allen wrench, seven hole covers, rubber
thermometer holder and instruction manual.
„
Box 2 contains the bath housing, including the electronics drawer.
Box 2 also contains a smaller box with the motor and stirrer, includ-
ing the impeller and mounting plate.
The bath unit housing is shipped completely assembled. However, the
glass jar, the glass panels, and the motor and stirrer must be installed in it.
To allow this, some disassembly of the bath unit housing is required. The
tools required are a utility knife, phillips screwdriver, and a 1/8" Allen
wrench. The Allen wrench is included with the bath.
Assembly procedure
1. Unpack the bath unit housing.
Figure 2: Primary bath components after unpacking