Cres Cor 1000-CH-SS-SPLIT - Manual (Page 7)

Ovens FL-2340
Rev. 5 (7/08) Page 7 of 14
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
5925 Heisley Road • Mentor, OH 44060-1833
MAINTENANCE INSTRUCTIONS
TROUBLE-SHOOTING GUIDE
IF UNIT GETS TOO HOT OR WON’T SHUT OFF, DISCONNECT
POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!
1. Cord is unplugged from wall outlet.
2. Circuit breaker/fuse to wall outlet is blown.
3. Switch(es) are turned off.
4. Thermostat(s) are turned off, or are set too low.
If hot unit is NOT working, fi rst check the following causes:
PROBLEM POSSIBLE CAUSE SOLUTION
Oven does not heat, or doesn’t heat
properly
1. Thermostat(s) defective
2. Heater contactor
3. On/Off Switch
*4. Fuses
1. Replace
2. Replace
3. Replace
4. Replace
Timer runs down, but oven does not go
into hold mode.
Timer defective Replace
Heaters will not shut off
1. Thermostat defective
2. Contactor defective 1. Replace
2. Replace
Vent fans do not shut off
1. Vent fan switch defective
2. Control compartment is still hot.
1. Replace
2. Wait until it cools
Check “Heaters will not shut off”
Vent fans do not operate
(See Note)
1. Vent fan switch defective
2. Vent fan defective
*3. Fuses
1. Replace
2. Replace
3. Replace
*Fuses are in 6000 Watt units only
NOTE: Vent fans will not operate until the control compartment requires ventilation to limit temperatures.
Replacement of electrical components must be done by a qualifi ed electrician.
Refer to our Service Agency list, FL-1400 (found in the back of this manual), of authorized service
centers.
WARNING