Checkline ESM301 - Manual (Page 18)

Model ESM301 / ESM301L Version 2 Test Stand User’s Guide
18
3. Cycling Mode (travel indication not enabled):
Note: The min and max keys will not appear when a password has been set.
4. PC Mode
Appears the same as in Basic and Auto Return modes.
Label Description
menu Enters Test Parameter Setup
min Sets speed to minimum speed. Will not appear when a
password has been set.
max Sets speed to maximum speed. Will not appear when a
password has been set.
set Sets speed to the programmed SPEED, UP SPEED, or
DN SPEED setting
Pressing menu will enter Test Parameter Setup. If a password has been programmed, the
display will prompt the following:
The password is a four digit number. The first digit in the password will be flashing, signifying that
it is active and can be incremented by pressing +. To advance to the next digit, press –>. Change
subsequent digits in the same fashion. Once the complete password has been entered, press
ENTR.
If correct, the display will enter Test Parameter Setup Mode. If the password is incorrect,
the words INCORRECT PASSWORD will flash, and the display will revert to Operating Mode.
5.3 Basic Mode
The crosshead moves upward when UP is pressed, and downward when DOWN is pressed. When the
crosshead is in motion, an LED indicator on the button pushed will be illuminated. The KEYS setting
controls how crosshead movement responds to the push of the UP and DOWN buttons. The three
settings are:
1. Maintained (default)
The crosshead will move continuously once the button has been pressed. Subsequently
pressing STOP during a test will stop crosshead motion.
2. Momentary
The crosshead will move only if the button is pressed and held. Releasing the button will
stop movement immediately.
3. Auto
Holding down the button for more than 0.5 seconds will enter Momentary mode, at which
time an audible indicator will sound and the LED indicator on the button pushed will be
illuminated. A short tap on the button will operate the test stand in Maintained mode.
Pressing STOP during Maintained mode will stop crosshead motion. To resume the test,
press UP or DOWN again.
Pressing EMERGENCY STOP will immediately stop crosshead motion in any mode. To release, twist the
C Y C L E S : 0 0 0 2 4
me n u m i n ma x S E T
P A S S WO R D 0 0 0 0
E S C
− + E N T R
TRAVEL CYCLES REMAINING