Checkline KXE - Manual

– 1 –
Table of Contents
1.0 Introduction .......................................................................................................... 0 3
1.1 Models
1.2 Unpacking
2.0 Overview ............................................................................................................... 0 4
2.1 Controls
2.2 Complete kit
2.3 Optional accessories
3.0 Set-Up Procedures ................................................................................................ 0 5
3.1 Battery Insertion and Replacement
3.2 Power On and Off
3.3 Reversing the display
3.4 Zero adjustment of the measuring positon
4.0 Taking A Measurement ........................................................................................ 0 7
4.1 Inserting the process material
4.2 Measuring the process material
4.3 Removing the process material
5.0 Damping Mode ..................................................................................................... 0 8
5.1 Switching Damping on and off
5.2 Modifying the Damping Factor
5.3 Setting a new Damping Factor
6.0 Memory Modes .................................................................................................... 0 9
6.1 Memory Mode selection
7.0 Data Logging ......................................................................................................... 11
7.1 Data logging in Mode “S” (Standard)
7.2 Data logging in Mode “C” (Continuous)
7.3 Data logging in Mode “L” (Limit)
7.4 Data logging in Mode “F” (Fast)
8.0 Recalling the stored tension values ..................................................................... 15
8.1 Recalling stored tension values in Mode “S” (Standard)
8.2 Recalling stored tension values in Mode “C” (Continuous)
8.3 Recalling stored tension values in Mode “L” (Limit)
8.4 Recalling stored tension values in Mode “F” (Fast)
– 28 –
Notes