Checkline RH1 - Manual (Page 5)

 Electromatic Equipment Co., Inc.
-12-
9.0 PRINT SAVED DATA
To print your saved data, connect the device to the printer
using the printer cable that was delivered with your
device. Carefully loose the protection cap on the moisture
meter. At first plug in the side of the connector with the
close plastic casing at the moisture meter. Then switch on
the device.
Not till then the other side of the cable has to be plugged
in at the printer. Switch on the printer by pressing
. Now
the green LED is blinking. If it does not blink, please
change the batteries and try again.
Press the button at your moisture meter until you reach
the menu (see image on the right). Choose „Print Logs“
and confirm by pressing .
Now you can select if you want to print the last saved
measuring series or all saved measuring series (logs).
Confirm by pressing
again. The selected logs are
printed out now.
To save paper, please think of clearing the data storage
regularly.
Online Print and Online Send
Your device supports the function “Online Print” and
“Online Send”, this can be activated in the menu
„Options“. If an option is active, every newly recorded log
will immediately be printed or transferred to the PC after
pressing
key.
 Electromatic Equipment Co., Inc.
-5-
5.0 MENU
There are 4 menu levels.
The symbols show the key functions in the different menus.
1. Type selection:
2. Saving:
3. Additional level:
Rolling Menu: Use this key to enter the different menu levels and main menu.
Power: Press this key for to switch the instrument off (5 sec.) or on (3 sec.).
Press this key briefly to activate the display lighting.
Up: This key moves you to the next type/calibration curve.
Down: This key moves you to the previous type/calibration curve.
Disk: Use this key to save measurement values.
If this symbol and a number are beside the disk symbol an AutoLog series is
started.
If only a number is shown in front of the disk symbol the measurement value can be
saved manually (manual log). Zero means that the number of values saved at that
time is zero.
Alternatively: Hold: The currently shown measurement value is held. It is
released when another key is pressed.
View logs: If no logs are active (the last measuring series has been
completed), you can use this symbol to view the saved measuring series.
Alternatively:
Edit logs: If logs are active (the current measuring series is not yet
completed), you can press this symbol and then enter e.g. batch number and
supplier’s data for the series.
Edit type: This symbol has no function on RH1 and RH5.
In the additional level, press
(Rolling Menu) to enter the main menu.