ChemoMetec NC-200 - Manual (Page 35)

991-0204 Rev. 1.1 September 2012 35
Add cells outside marker to image overlay: Same as the inside-option (see above), but for cells
outside selected marker.
Note: Adding cells to the image overlay is cumulative. Hence if you use this to select both inside and
outside cells you may assume that all cells in the image should be marked with an enclosing square. This is
however, not always the case. If certain cells have been excluded from the cell population, e.g. all non-
single cells, then these are not part of the scatter plot, and hence will not be included in the selected cells
list.
Scatter Plot in Plot Manager
The scatter plot is used to plot two user selectable parameters against each other together with protocol-
or user defined polygons which marks, gates and counts cell populations.
Data source indicator: A small colored square in the upper left corner indicates the source of the cell
population (see further details in row window).
Click the delete plot button to remove a plot from the row. This will leave an empty area in which you
via right click can insert another plot or completely delete the area.
Double click: To launch the large scatter plot double click in the plot area. In the large scatter plot you can
define axis parameters, polygons and gating settings.
Right click: Shows the context menu offering the following options:
 Show large plot (dbl-click)
 Copy BMP to clipboard
 Copy selected gate to clipboard