COP-USA CD54W-35Y - Manual (Page 11)

Operation Manual for Intelligent Speed Dome Camera
10
Bad connection of the power Make correction
Transformer damaged Replace
On power cannot self-check
have image but have motor
noise Mechanical failure Repair
Camera incline Reinstall
Power supply not enough Replace
Self-check ok, but have no
image
Video signal fault Reinstall
Bad connection of the video Press to full connect
Camera damaged Replace
Self-check ok but cannot
control
RS485 Bus bad connection Check the RS485 connection
Dome id setting is wrong Reselect
Protocol setting is wrong Reset and on power again
Vague image
Bad connection of the video Press to full connect
Power supply not enough Replace
On power cannot control
Self check error On power again
Bad connection of control Press to full connect
Bad control of matrix On power again