COP-USA DVR2708XD-M - Manual (Page 39)

DVR User Manual
34
(SSL); user can setup mail servers (such as Gmail) as required.
Send address/password: Sender‟s email address/password
Receive address: Receiver‟s email address. Here user can add at least three mail addresses.
Click TEST button to test the validity of the mailbox.
Attaching image: After selecting it, the system will attach images when sending the
emails.
Fig 4-29 Network Configuration-Email
4.6.4 Server
This function is mainly used for connecting ECMS. The setting steps are as follows:
Step 1: In the server tab, select “enable” as shown in the Fig 4-30.
Step 2: Check the IP address and port of the transfer media server in the ECMS. The
default server port for auto report is 2009. If it is modified, please enter into the
transfer media interface to check.
Step 3: Enable the auto report in the ECMS when adding a new device. Then input the
remaining information of the device in the ECMS. After that, the system will auto
allot a Device ID. Please check it in the ECMS. Fig 4-30 Network Configuration-Server
Step 4: Input the above-mentioned server IP, server port and device ID in the server interface .Then click “Apply” button to save settings.
Now, the ECMS system will automatically connect this device.
4.6.5 Other Settings
If your DVR is setup to use PPPoE as its default network connection, you may setup DDNS to be used in connection. The setting steps are