COP-USA PKG-DVR04 - Manual (Page 78)

78
elected the channel <Channel switch> button in the <preview interface>, the channels group will switch to 5
~ 8, 8 ~ 12, 12~16 and circulation switch. As shown in the below image.
Chapter Chapter Chapter Chapter S S S Seven even even even FAQ FAQ FAQ FAQ (Frequently (Frequently (Frequently (Frequently Asked Asked Asked Asked Questions) Questions) Questions) Questions)
01：Why the DVR did not run after connect the power supply?
①Please check the power switch turn on or off at the rear panel of DVR.
②Please check if the turn on DVR operation correct or not?
③If you select the adaptor +12V, 5A or above? (8ch 5A, 16ch 220V 200W)
02：Still stop over on the boot-strap frame?
Physical damaged in hard disk drive
Boot manager abnormal.
03：Why does appear the boot running too slow?
①There are too much capacity data in hard disk drive, the system will automatic search the data when
the system boot up, caused the boot running slow.
② The hard disk drive error will cause the system research the data repeatedly, caused the boot
running slow.
04：Why does the system reboot repeatedly?
①Check the hard disk drive, if there is not the FAT32 formatted in it or the problem in it and caused the
DVR reboot;
② Please check the power supply of DVR, if you installed a lot of hard disk drive, it may be reboot