COP-USA DVRC264-8ME-A - Manual (Page 37)

DVR User Manual
31
Alarm out includes three sub menus: alarm out, schedule and buzzer
To setup alarm out:
Step 1: Enter into MenuSetupAlarm out tab. Refer to Fig 4-28. Input relay
name and hold time.
Step 2: Select the Schedule tab. This will bring up the schedule setup
interface. The setup steps for schedule for alarm out are similar to normal
schedule setup; you can refer to 4.4.1 Schedule for details.
This step is very important for alarm out. Even if you have enabled alarm out in
the motion based alarm or sensor based alarm, you will not see the result of Fig 4-28 Alarm Out
alarm out if no schedule is added here.
Buzzer
It is an inbuilt alarm output device. To setup Buzzer:
Step1: Enter into MenuSetupAlarm out Buzzer tab;
Step2: Checkmark Buzzer and set buzzer alarm hold time. This would trigger the
buzzer when the system is in alarm.
4.6 Network Configuration
Network configuration includes five submenus: network, sub stream, Email,
server and other settings. Network settings must be configured if DVR is used for
monitoring over network.
4.6.1 Network
Step 1: Enter into MenuSetupNetworknetwork tab. Refer to Fig4-29:
Step 2: HTTP port: the default value is 80. If the value changed, you need to
modify the IP address in the IE address .i.e. if HTTP port is set to 82 and IP
address is,
192.168.0.25 , then you shall input IP address as Fig 4-29 Network Configuration-Network