Cub Cadet CC 500 BAT - Manual (Page 13)

ELECTRICAL SYSTEM
9
Initial trouble shooting
The first step in trouble shooting this mower is to make
sure the circuit breaker is set. To do this, first make
sure the mower is cold (has not been operated for at
least five minutes). Next push the breaker in.
See Figure 2.13.
Next, make sure the safety key is in place. The safety
key acts as a fulcrum for the switch. With out it, the
switch can not operate. See Figure 2.14.
Figure 2.13
Breaker
Safety key
Figure 2.14
Safety key
After assuring the breaker is set and the safety key is in
place, remove the motor cover by following the steps
outlined in Chapter 3: Repair Procedures, and check
the fuse. If the fuse is ok, then troubleshoot the electri-
cal system of this mower by looking at three compo-
nents:
• The switch box assembly
• The batteries
• The motor
NOTE: Before attempting to trouble shoot this
mower, make sure the batteries are fully
charged.