Cub Cadet LT-2180 - Manual (Page 41)

41
Figure 55
7. Carefully guide the tractor inplement lift links (left
and right) into the rear deck bracket slots (left and
right) as the tractor implement lift handle is
lowered to its lowest setting (Refer to Figure 56).
8. Pull both deck support pins outward and rotate
rearward to disengage the outer surface ot the rear
deck brackets. Release the pins, making certain
each deck support pin passes through the inner
hole of the rear deck bracket. The spring tension
will push the pins inward and, if aligned, through
the hole in each implement lift link (See Figure 56).
Figure 56
NOTE
It may be necessary to lift each side of the deck
and maneuver it slightly to align the support
pins with the holes of the lift links. Make certain
the support pins are fully extended through the
lift links to prevent the mower deck from
disengaging the lift links while mowing.
WARNING
The deck idler arm lever is spring loaded.
Release it slowly.
9. Disengage the deck idler arm lever from its stop
bracket and release the spring tension by rotating
the lever out and rearward (See Figure 57).
Figure 57
WARNING
The exhaust system is HOT. To avoid personal
injury, allow the engine and exhaust system to
cool before proceeding with the following PTO
belt installation instructions.
10. Open the tractor hood and install the forward end
of the PTO belt onto the PTO clutch pulley on the
front of the engine. Ensure that the narrow side of
the PTO belt engages the groove of the pulley
(Refer to Figure 58).
REAR DECK
BRACKET SLOTS
DECK SUPPORT
PIN DISENGAGED
DECK
IMPLEMENT
LIFT LINKS
(BOTH SIDES)
LIFT LINK HOLE
(BOTH SIDES)
SLOT IN REAR
DECK BRACKET
DECK SUPPORT
PIN ENGAGED
IDLER ARM
LEVER
LEVER STOP
BRACKET