Cub Cadet GT-2550 - Manual (Page 30)

30
Replace headlight bulbs as follows: (See Figure 25)
1. Unplug the wire harness leads from the headlight
socket terminals. Note which wire connects to
each terminal before disconnecting.
2. Rotate the socket assembly as follows to remove
from the reflector housing:
• Left headlight — appoximately 1/4 turn counter-
clockwise.
• Right headlight — approximately 1/4 turn clock-
wise.
3. Push the bulb inward and turn counterclockwise to
remove from the socket.
Figure 25
4. Align a locking post of the bulb base with the notch
in the socket, then push the bulb inward and turn
clockwise to lock
5. With the terminals pointing upward, align the tab of
the socket with the notch of the reflector. Push the
socket inward and turn as follows to lock:
• Left headlight — appoximately 1/4 turn clock-
wise.
• Right headlight — approximately 1/4 turn coun-
terclockwise.
6. Connect the wire harness leads to the appropriate
socket terminals.
FUSES
Always use the same capacity fuse for replacement.
Refer to SPECIFICATIONS. If the electrical system
does not function, check the fuses.
To replace a fuse, pull the old fuse from the fuse holder
and install the new fuse.
GENERAL BATTERY INFORMATION
WARNING
a. Battery posts, terminals and related
accessories contain lead and lead
compounds. Wash Hands after handling.
b. Should battery acid accidentally splatter into
the eyes or onto the skin, rinse the affected
area immediately with clean cold water. If
there is any further discomfort, seek prompt
medical attention.
c. If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of
ammonia/water or baking soda/water.
d. NEVER connect (or disconnect) battery
charger clips to the battery while the charger is
turned on, as it can cause sparks.
e. Keep all sources of ignition (cigarettes,
matches, lighters) away from the battery. The
hydrogen gas generated during charging can
be combustible.
f. As a further precaution, only charge the
battery in a well ventilated area.
ALWAYS SHIELD EYES AND PROTECT SKIN AND
CLOTHING WHEN WORKING NEAR BATTERIES.
DANGER
BATTERIES CONTAIN SULFURIC ACID AND
MAY EMIT EXPLOSIVE GASES. USE
EXTREME CAUTION WHEN HANDLING
BATTERIES.
KEEP BATTERIES OUT OF THE REACH OF
CHILDREN.
MAINTENANCE OF BATTERY
The tractor is shipped with a wet battery — the battery
acid has already been added and the battery sealed.
Although the battery is maintenance free, the following
care should be taken when handling the battery and to
assure its proper life cycle.
1. Spray the terminals and exposed wire with a
battery terminal sealer, or coat the terminals with a
thin coat of grease or petroleum jelly, to protect
against corrosion.
2. Always keep the battery cables and terminals
clean and free of corrosion.
3. Always keep the terminal covers in place over the
battery terminals.
4. Avoid tipping. Even a sealed battery will leak
electrolyte when tipped.
REFLECTOR
NOTCH
SOCKET TAB
TERMINAL
SOCKET
REFLECTOR
HOUSING