Cub Cadet 200 Series - Manual (Page 10)

200 Series Single Stage Snow Throwers
6
6.2. Remove the three screws securing the front of
the shroud to the auger housing using a 3/8”
wrench.
6.3. Remove 4 screws (2 on each side) securing the
shroud to the frame.
6.4. Lift the fuel tank up along withe wire brackets
that are weaved in slots on the side of the frame.
NOTE: If there is fuel in the fuel tank it will be
necessary to pinch off the fuel line and discon-
nect the fuel line from the carburetor.
NOTE: To provide a clear view of the fuel tank
bracket the lower chute was removed.
7. ENGINE SUPPORT BRACKET
7.1. Although any engine related issue would be
resolved through the engine manufacturer it is
important to be aware of changes in how the
engine is secured in the machine.
7.2. A new support bracket is used to add addi-
tional support from its previous predecessor.
See Figure 7.2.
Figure 6.2
Shroud Screws
Figure 6.4
Figure 7.2
Engine support bracket