EKLIPES EKLIPE Bike-2-Bike Jr. Plug-In 2000 Amp EZ Jump-Start Kit - Manual (Page 2)

Note ! Before Installation Check all Dims 12 gauge Female BMW Jumper Plugs (As Seen in Picture Below) on your Harness
and Alligator Clips to make sure there has been no damage to the 12 Gauge plug wires connected in the Plugs before you
install anything to your Battery.
These Plugs (The Female BMW Plugs) Do not have an inline fuse link, so make sure you test the Dims Female BMW plug as
seen in the picture below continuously during your installation.
Check BMW Plug before installation to the battery to make sure Electrical connectors are securely connected on the Plug
before you attach eyelets Red and Black to Battery Terminals to prevent shock.
To Check and inspect female BMW Plug connectors slide back external housing on harness down the wires towards the Fuse
link to make room to unscrew BMW plug housing to check connectors as seen in pictures 1, 2, & 3 Below. Note! Make sure
Both Connector plugs (Red and Black) are securely connected to their mini plugs (as seen Above in Picture) inside the female
BMW Plug and are securely tight. Copper Pin is Positive, Brass Pin is Negative
Make sure the positive and negative connectors inside the plug as seen in the picture above are securely tight before you
attach the ring terminals of the harness to the battery terminals as this part should be last after making sure you have not
damaged the plug.
During installation you must be careful as to NOT pull on the Female BMW Plug when you are feeding the wiring harness
from your battery to snub out to the side of your Motorcycle as seen in the picture below.
Note! DO NOT pull on any of the electrical plugs!! Pulling on the BMW Female plug will cause damage to the plug
connector wires on the inside of the dims female BMW plug and cause an electrical short in the circuit wire and may cause
severe damage or even fire. This will immediately cause a faulty installation and damage the electrical system.
Always test and check voltage continuity on plugs before, during and after any installation for safety to make sure you
have not damaged anything during your installation.
Disclaimer: Please Note: We at Brookshire Innovations LLC do not do installations of any of our products and therefore we
do not take any responsibility or liability for any damage caused by a faulty installation from damage done to any of the
electrical wiring systems caused by the installer during installation.
As such you the customer hereby agree to install this product at your own risk and with no liability
to Brookshire Innovations LLC
Furthermore, if you are not experienced with working on Motorcycles, or any other Power Sports vehicles we recommend you
have your new EKLIPES™ unit installed by an Authorized Motorcycle Dealer.