Holtgreven GSE-375 User Manual
Page 77
71
2. Enter
100.
DISPLAY READS 100
3. Press
[ZERO] or [SAMPLE/Enter] to establish span.
DISPLAY READS 100.00
4. Pause for motion delay.
DISPLAY READS Cal ~ Good? ~ 100.00
When making a significant change to the previous calibration, or when the calibration weight is
less than 5% of full scale capacity, ReCal ~ ??? will be displayed instead of Cal ~ Good? In this
event it is recommended that the calibration be performed a second time. Press [TARE] or
[SAMPLE/Enter] to recalibrate, or press [ZERO] to skip recalibration.
E
E
x
x
i
i
t
t
i
i
n
n
g
g
C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
o
o
n
n
Once zero and span have been established, the newly acquired calibration information must be
saved to non-volatile memory before it will be realized in the Weigh Mode.
To exit and save calibration information:
1. Press
[TARE] or [SAMPLE/Enter] to accept calibration.
DISPLAY READS Enter ~ =Stor
2. Press
[TARE] or [SAMPLE/Enter] to save calibration.
DISPLAY READS Enter ~ =End
3. Press
[TARE] or [SAMPLE/Enter] to exit calibration.
DISPLAY READS 100.00
To exit without saving calibration information:
1. Press
[TARE] or [SAMPLE/Enter] to accept calibration.
DISPLAY READS Enter ~ =Stor
2. Press
[CLR].
DISPLAY READS Enter ~ =Undo
3. Press
[TARE] or [SAMPLE/Enter].
DISPLAY READS Enter ~ =End
4. Press
[TARE] or [SAMPLE/Enter] to exit calibration.
DISPLAY READS 99.66
A
A
n
n
a
a
l
l
o
o
g
g
O
O
u
u
t
t
p
p
u
u
t
t
C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
o
o
n
n
The analog output calibration procedure establishes explicit zero and full scale values for each of
the three analog output modes: 0 - 10V, 0 - 20 mA and 4- 20 mA. There are five adjustment
values for the analog option, located at the information parameters P61200 through P61205 that
allow the zero and full scale output of each mode to be adjusted to exact values. This allows the
analog option to be configured to match the needs of the system being connected to its outputs.
The calibration values for each of these modes have been determined at the factory. These
values are provided on paper with each board to make calibrating the analog option a simple
When saving calibration, parameters changed in the Setup Mode are also saved with their new
selections.