Industrial Data Systems IDS DT200 User Manual

Page 30

Advertising
background image

DT 200 Users Manual version 1.E

Set Operation Parameters

26

2 - CONDEC: <st><polarity><weight><units><mode>>status><terminate>

Polarity:

space (positive weight), - (negative weight)

Weight:

7 characters, zero blanked, with decimal point

Units:

L (lb), K (kg), T (ton), G (gram), O (oz)

Mode:

G (gross mode), N (net mode)

Status:

<space> (valid weight), M (motion), O (over wt), I(invalid)

Terminate:

lf, cr (line feed, carriage return)

3 - WEIGHTRONIX: <mode1><mode2><polarity><weight><space><units><term>

Mode1:

space (gross mode), 0 (zero if net mode)

Mode2:

G (gross mode), N (net mode)

Polarity:

+ (positive weight), - (negative weight)

Weight:

6 characters, NOT zero blanked, with decimal point

Units:

lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)

Terminate:

lf, cr (line feed, carriage return)

4 - OHAS:

<polarity><weight><space><units><2 spaces><mode><status><term>

Polarity:

space (positive weight), - (negative weight)

Weight:

7 digits, zero blanked, with decimal point

Units:

lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)

Mode:

G (gross mode), N (net mode)

Status:

<space> (valid weight), M (motion), O (over wt), I(invalid)

Terminate:

lf, cr (line feed, carriage return)

5 - Print label 85: transmits the contents of parameter 85 (print label 85)

Data entered into a print label can include register data:

[253] [reg no] buffer register data, minimum size (zero blanked no spaces)

[254] [reg no] buffer data, 7 character field, zero blanked, right justified.

Printer Parameters

The DT200 provides a universal printer interface for various printers. The printer

interface allows you to select and customize the data output for serial or parallel printers.

The serial interface option uses Serial Port 1 (TB1) for connection to the printer. The

parallel interface uses the TTL I/O Port (TB4) for connection to the printer. Refer to the

“HARDWARE INSTALLATION AND WIRING “ section for information on connector

pin designations. NOTE: The parallel interface may not be available if the DT200 is

configured to use setpoint outputs.

Parameter 29 Printer Port Select (2 [Serial Port 1])

Enter a number from the following list to select a printer option:

1 Parallel Printer interface.

Advertising