KEYENCE LK-H2 - Manual (Page 38)

3-14
3
3 Window Functions and Operation
„ Setting scaling from measurement data
1
Click "Set from the Measurement data".
A confirmation dialog appears.
2
Click "Yes".
The "Scaling Setting" dialog appears.
The controller enters communications mode when "Scaling Setting" is in progress.
3
At the reference surface, click "Set" for "Input1".
This sets the measurement data of the reference surface into "Input1".
4
Insert the master work piece, then click "Set" for "Input2".
This sets the measurement data of the master work piece into "Input2".
5
Set the scaling display values in "Display1" and "Display2".
6
Click "OK".
NOTE