KEYENCE TM-3000 Series - Manual (Page 3)

3
II -
11
Operational flow for measurement
Manual P5-37
This section explains settings required to perform measurement.
This measurement sensor measures outer diameters or the distances based on the edge information
(boundary of a bright and a dark part of the image) of measured images.
For detailed measurement content, specify the “Measurement type” in the “Measurement setting” and set.
Set the target within the measurement area and perform the
master registration.
Select the measurement type according to the measured content.
(The “Measurement type” can be selected in the measurement setting.)
Setting procedure
Step
1
Step
2
Measurement types T
Diameter :
Maximum diameter
Intersection (X and Y coordinates)
Intersection
distance
Distance between point
and straight line
Y position (Y axis)
X position (X axis)
Step height :
Step height
Width :
Minimum diameter
Width
Angle
Radius
Roundness
Pitch
Manual P5-43
Manual P5-48
Manual P5-52
Y position :
X position :
Coordinate :
Manual P5-46
Manual P5-50
Manual P5-63
Distance :
Intersection distance :
Area :
Manual P5-54
Manual P5-56
Manual P5-65
Angle : Manual P5-58
Radius :
Roundness :
Manual P5-60
Manual P5-62
Pitch : Manual P5-70
Diameter, step height, width
The maximum diameter and minimum diameter
within the specified range, and step height and
width between detected edges are measured.
Angle
This measures the angle made by the detected
two straight lines or the tilt from the arbitrary line.
Radius, roundness
This measures the radius of specified arc
and the roundness.
Pitch
This measures the maximum, minimum or
average pitch within the specified range.
Y position, X position, coordinate
Y position, X position of detected edge, or
coordinate at the specified point is measured.
Distance, intersection distance, area
This measures the distance between the specified two
points, such as distance between center of circle and
intersection, and also measures the area.
Operational Flow for Measurement Operational Flow for Measurement
II
Area
Tilt from the arbitrary line
* If position change, etc. occurs for the measurement target, use the position correction
function (page 9 in this manual).
The measurement area is corrected by the amount of change and the target
measurement is taken.
Distance between the centers of two targets