KEYENCE BL-700 Series - Manual (Page 92)

Chapter 4 Installing the Setup Software
78
4
4. If you click [Stop], received data is not listed. (The button name is changed to
[Start].) If you try to display received data again, click on [Start].
5. When you enter a command in the “Send command” field, you can send the
command to the BL-700 (or BL series). The format of the command to be sent
is “[Command] + [CR]”. Typing command and pressing [ENTER] key sends the
command.
6. When you click on the [ARROW] button in the “Send command” field, the
commands previously sent are listed. (Up to 100 commands can be listed.)
7. Click on [Quit] to quit this mode.