Kofax INDICIUS 6.0 User Manual
Page 59
Configuring Recognition and Correction
Getting Started Guide (Fixed-Form)
53
If, however, the boxes are irregularly spaced or there is a large amount of text or
other marks attached to the boxes, each box should be defined as a single mark sense
field. Completion can then be configured to group the data for these fields into a
single field for keying.
Mark sense fields are created in a similar way as text fields, but the Allowed
Characters, Weights, Confidence and Correction Limit parameters are not required.
Recognition uses knowledge of minimum character sizes to determine whether or
not a mark is present in a field.
1
Select the Formid 1 tab.
2
Click on the
(Mark Sense) button on the toolbar.
3
Draw the field over the “Mr” check box and configure the field by setting the
properties as shown in Table 5-9.
Figure 5-15. Mark Sense Field
Table 5-9. Mark Sense Field Configuration
Property Value
Name: Mr
Left: 375
Top: 800
Right: 497
Bottom: 918
Minimum Character Size:
11 x 28
Expected Character Size:
76 x 76
Maximum Character Size:
108 x 106
Box Size:
91 x 89