Panasonic PV-DAC10 - Manual (Page 5)

Supplying Power
Insert the DC Cable into the DC IN
Terminal on this unit.
Connect the other end of the DC
Cable to the AC Adaptor as shown.
Plug in the AC Adaptor.
• The POWER Lamp of the AC Adaptor
lights up.
i0
About the AC Adaptor
• When the 50% and 100% Charge Lamps
flash alternately, or when the Charge
Lamps do not light, remove and then re­
attach the Battery. Or, attach the Battery
to the Palmcorder, use it for 10-20
minutes, and then re-attach the Battery to
the AC Adaptor. If it still cannot be
charged, consult with your dealer.
• When the Battery is hot, charging takes
longer than normally.
• If you remove and re-attach the Battery
during charging, the lit Charge Lamp may
change, but this is normal.
• If you remove and re-attach the Battery
during charging, the Charge Lamp may go
off momentarily while the AC Adaptor is
checking the change remaining in the
Battery, but this is normal.
When not in use, unplug the AC Adaptor
from the AC outlet. (AC Adaptor
consumes 1W of electric power when
plugged into an AC outlet even when not
in use.)
Even if you connect the AC Cable (or the
Car Adaptor) during charging, the Charge
Lamps wilt keep flashing for a while and
indicate the charging condition.
' If you use the AC Adaptor very close to a
radio while listening to a broadcast
(especially in the AM range), the reception
may be distored by interference. Use the
AC Adaptor more than 1 meter away from
a radio.
During use, the AC Adaptor may emit
some sound, but this is normal.
After use, be sure to disconnect the AC
Cable from the AC outlet, (if it is left
connected, approximately 1W of power
will be consumed.)
It may take a short time before the AC
adaptor’s POWER Lamp lights, but this is
normal.