Panasonic EY3530NQMKW - Manual (Page 14)

WARNING
• When making an incomplete cut or cutting is interrupted, or blade is binding or cutter is
stalling; release the trigger immediately and hold the cutter motionless in the material until
the blade comes to a complete stop. To avoid kipkback, never attempt to remove №e cutter
from the work or putt the cutrer backward while the blade is In motion. Make sure the blade
has come to a complete stop, then remove cutter from cut. To resume cuttmg, start metal
cutter, allow the blade to reach fuN speed, reenter №e cut tiowly and resume cutting.
4. Place the wider part of the cutter base on the part of ttte work piece which is solidly supported
(Rg. 11), never on the section that will kail off when the cut is made(Rg. 12).
• Hold the cutter firmly to prevent loss of control. Working carelessly can cause severe personal
injury.
5. Make sure the blade stops.
Even though your metal cutter has an automatic brake, before setting the metal cutter down,
make sise the Made has come to a complete stop and the lower blade guard has dosed.
6. Do
rK)t
use if anything seems unusual. Remove battery pack immediately.
• If the metal cutter body becomes very hot, or does not work property, remove the battery padt
aiKf
do not use. Have it checked by an authorized service center.
WARNING
Do not try to repair the metal cutter yourself. Never disassemble or modify the metal cutter
body. There are no user-repairable parts inside.
7. • NEVER ALLOW THE CUTTER TO COME IN CONTACT WITH YOUR BODY.
• After completing a cuL do not allow the cutter to brush against your leg or side.
Since the tower guard Is retractable. It could catch on your dothlng and expose the blade.
Keep dotNng away from metal cutter. Be aware of the exposed blade sections that exist in
both the upper and lower guard areas.
_
15
—