Casio TC-540 - Manual (Page 23)

20 20 20 20 20
PAGE
CHARGING THE
BATTERIES
PROGRAMMABLE
PAUSE
1
Follow instructions on page 18 for storing
autodial numbers.
Charge the cordless handset batteries for 12-15
hours before using the handset for the first time.
The handset is always charging while it is in the
base unit and cannot be overcharged.
1
Check the AC Adapter to see that it is
connected correctly.
2 Place the handset in the base unit. The
CHARGING INDICATOR on the
base unit lights to indicate the TC-540 is
charging.
2
Press HOLD/PAUSE on the base unit
when a pause is required. Each pause is 2
seconds in length and counts as one digit
in the autodial memory.
Example: 9 PAUSE 1 2 1 3 5 5 5 1 2 1 2
BATTERIES - The TC-540 is
shipped with the handset battery
pack installed. If it becomes
necessary to remove or replace
the batteries see page 32.
CHARGING
HANDSET LOW
BATTERY INDICATOR
When the battery pack needs recharging, the
LOW BATTERY INDICATOR (LO BATT)
on the handset will flash. You may also notice a
reduction in the quality of your cordless handset
communications. Return the cordless handset to
the base unit when the LO BATT indicator is
flashing.
NOTE: The batteries can be recharged many times, but if you
get a low battery indication even after 12-15 hours of charging,
you should replace the battery pack.
PROGRAMMABLE PAUSE &
BATTERIES
BOTH
Pause is convenient for use on a business
telephone system (i.e.: PBX) when an 8 or 9
must be dialed to reach an outside phone line.
This feature can also be used for a long
distance service (i.e.: MCI) where you have to
wait for a second dial tone before you continue
dialing.
LO BATT
VOLUME AUTODIAL FLASH FLASH
BOX 1 BOX 2
LO BATT
BOX 3
MESSAGE
4 GHI
7 PRS
1
5 JKL 6 MNO
3 DEF 2 ABC
8 TUV 9 WXY
0 OPER * #
SKIP REPEAT
TONE
HOLD SCREEN
PLAY
TALK
ERASE SAVE
HOLD
PAUSE