Vermont Casting WOOD STOVE - Manual (Page 12)

HANDLE
Twist spring handle
in counter clockwise
motion while pushing on to handle; spring handle will
“thread” down to desired location.
SPRING
6” Flue Required
Figure A: Clearance from combustible constructions
From Heater From Chimney Connector
A Sidewall.................21-1/2” (546 mm) D Sidewall..................30” (762 mm)
B Backwall................15-1/2” (394 mm) E Backwall.................18” (457 mm)
C Corner...................18-1/2” (470 mm) F Corner....................25-1/2 (648 mm)
G Ceiling....................56” (1422 mm)
Model No. S130 / S130P
This unit has been listed by Warnock
Hersey Limited to meet or exceed
CSA B 366, 2M and ULC S-627 Canada
Part No S19003 Rev07
NOTE: Retain this sheet for future reference
Unit must be placed on a noncombustible floor protection equivalent to 3/8” millboard extending 18”
(457mm) in front and 8” (203mm) to side and back of unit per manufacturer’s instructions.
Consult your local building authorities for further information.
MADE IN CANADA BY CFM CORPORATION,410 ADMIRAL BOULEVARD, MISSISSAUGA, ON L5T 2N6 1
B
E
18”
A
D
8” 8”
8”
BACK WALL
S
ID
E
W
A
L
L
BACK WALL
C
F
C
F
S
ID
E
W
A
L
L
Figure “A”
CFM Corporation
Contact your local building inspector
prior to installation.
A permit may be required in your area.
3FT(1M) MIN
FROM ROOF
PENETRATION
2FT(635mm) HIGHER
THAN NEAREST
POINT OF ROOF
WITHIN 1OFT(3m)
MINIMUM OVERALL
HEIGHT FROM FLOOR
15FT(5M)
G
OPTIONAL FAN
An optional heat exchange blower is available for
this wood burning appliance. To order please see
the local dealer where you purchased your appliance.
CAUTION: Do not open fire-door to a point where it
would be in contact with the combustible sidewall.