A&D Weighing FXi-09 - Manual (Page 7)

5
2. Charging the Battery
Notes
Charging the battery before it is completely discharged will shorten the battery life.
Charge the battery fully, until the CHARGE LED indicator goes out. This procedure will take
about 10 hours.
During the charging operation, the battery can not be used.
Charge the battery as follows:
1. Make sure that the battery is completely
discharged before recharging.
How to determine when the battery is
completely discharged:
• When the power switch on the rear of
the balance is turned ON without the
AC adapter connected, the balance
does not operate or the balance
displays "
lb " (Low battery).
2. Turn the power switch on the rear of the
balance OFF.
3. Connect the AC adapter to the balance. The
battery will start charging. The CHARGE
LED indicator will blink during the charging
operation.
4. Charging will take about 10 hours. Be sure
to fully charge until the CHARGE LED
indicator goes out.
5. After charging is complete, disconnect the
AC adapter from the balance to avoid
recharging.
Power switch
(Turned ON)
Without the AC
adapter connected
Power switch
(Turned OFF)
CHARGE LED indicator
AC adapter Electrical outlet
About 10 hours later
(Blinking) (Off)
2
3
5
CHARGE CHARGE