Acura 2011 TSX - Advanced Technology Guide - Manual (Page 6)

K E Y L E S S M E M O R Y S E T T I N G S
2. Check the MID:
• If you have the correct remote, the driver ID that first appears on
the MID will match the ID number on the back of your remote.
Go to step 3.
• If the numbers do not match, follow these simple instructions:
- Remove the key from the ignition switch.
- Press the unlock button on your remote.
- Insert the key into the ignition switch, turn it to ON (II), and
check the MID. The driver ID that first appears on the MID
should now match the number on the back of your remote.
When linked, each remote (labeled 1 or 2 on the back) activates its own set of driving
position memory and customized settings (through the MID).
1. Verify that you are using the correct remote by inserting the key in
the ignition switch and turning to ON (II).
C h e c k p o i n t
3. Once you have the correct remote, you can begin to program your
Keyless Memory Settings.
C u s t o m i z i n g S e t t i n g s
D r i v i n g P o s i t i o n M e m o r y S y s t e m ( D P M S )
1. Turn the ignition switch to
ON (II). Shift into Park (P).
3. Press and hold the SET button
until you hear a beep, then
release.
2. Adjust your preferred seat
settings.
4. Press and hold the memory
button # corresponding to the
remote (1 or 2) you are using
until you hear two beeps.
* See Customized Settings in your owner’s manual for other programmable settings.
Note: A stored memory position is linked to the corresponding keyless remote
(1 or 2). The driver’s seat begins to adjust when you unlock the driver’s door
with the remote and enter the vehicle.
9 8
11 TSX 4D ATG:ATG_NEW STYLE 9/9/2010 2:31 PM Page 7