Acura 2004 TSX - Owner's Manual - Manual (Page 152)

The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pressing the PWR/
VOL knob, the AM/FM button, or
the AUDIO DISPLAY button. Adjust
the volume by turning the knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
seen in the upper display if the
station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset icons.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob to the right to tune to
a higher frequency, or to the left to
tune to a lower frequency.
The SEEK function
searches the band for a station with
a strong signal. To activate it, press
the SEEK bar (
or ), then
release it. Depending on which side
of the SEEK bar you press, the
system scans upward or downward
from the current frequency. It stops
when it finds a station with a strong
signal.
The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, push and release the
SCAN button or touch the SCAN
icon at the bottom of the display.
You will see SCAN in the display.
The system will scan up the band for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds. If you do
nothing, the system will then scan
for the next strong station and play
that for 5 seconds. When it plays a
station that you want to continue
listening to, press the SCAN button
or touch the SCAN icon again.
CONTINUED
Operating the Radio TUNE
SEEK
SCAN
Audio System
Comf ort and Convenience Features 149
Main Menu Table of Contents