Canon VB150 - Manual (Page 4)

Dc In 13V
In Out 100/10BT
CC1
RS232C Video In
Ethernet
CC2 V1 V2 V3 V4
Slot-A
Slot-B
1 2 2 1
A B A B
+ - + -
LAN
cable
Ethernet
RS-232C
cable
Video cable
(RCA)
External
device
output
External
device
input
Camera
VB150
Ethernet
Sensor A
Lighting unit
VC-C4R
Power
supply
unit
Lighting unit
ON/OFF
Camer
a control
and video images
Door opening signal
Sensor B
Connector Attached Cable
Sensors mounted on the door In1
Lighting unit via the power supply unit Out1
Video cable for the VC-C4R camera V1
Control cable for the VC-C4R camera CC1
Using the Still Picture Recording Function Linked to an External Device
This is a monitoring system in which the lighting unit needed to take pictures switches on when the
door opens and the VC-C4R camera mounted on the ceiling captures still pictures. The equipment
shown in the figure below is connected to the terminals on the rear of the VB150 at installation.
Sample application in combination with a door-opening sensor and lighting unit
By using the "External Device Input 1/2" setting and connecting devices such as sensors and switches to
the VB150, you can construct a monitoring system that operates in response to external events. The still
pictures captured in this way are stored on a flash memory card inserted into the VB150. ( → VB150 User's
Manual P.46)
Installation Example
When the door opens and
Sensor B moves away from
sensor A, external device
input In1 generates an ON
event.
In response to this event,
Out1 is controlled to switch
on the lighting unit, pictures
of the entrance are captured
by the camera and the
pictures are stored on a
flash memory card.
VB150 Connection Example
a
Warning
● Do not directly connect the power cord for
the lighting unit to OUT1 or OUT2.
● Please also refer to page 102 of the VB150
User's Manual.
1