American Diagnostic Corporation (ADC) Advantage 6012N User Manual
Page 7
After battery warning appears, the device will not work until the batteries
•
have been replaced.
If the blood pressure monitor is not used for long periods, remove the batteries
•
from the device.
Use “AA” Long-Life or Alkaline 1.5V batteries. Do not use rechargeable
•
batteries.
Functional check: Press and hold the «ON/OFF» button
•
down to test all the display elements. When functioning
correctly many icons will appear.
5.2. Cuff Connection
Insert the cuff connector into the opening provided on
the side of the device as shown in the picture.
6. MEASUREMENT PROCEDURE
Attention!
Find time to relax by sitting in a quiet atmosphere for some time before measurement.
•
Efforts by the patient to support the arm can increase the blood pressure. Make sure you
•
are in a comfortable, relaxed position and do not activate any muscles in the arm during
measurement.
Always measure on the same arm (normally left).
•
Remove any garment that fits closely to your upper arm. Do not roll the sleeve since it can
•
squeeze your arm and this can lead to false results.
Use only clinically approved ADC
®
cuffs.
•
If you want to follow the results of your blood pressure measurements, always perform
•
measurements at the same time of day, since blood pressure changes during the course of the day.
Measurements should be done after 5 minute rest to ensure accuracy.
•
6.1. Fitting the Cuff
Position the cuff flat on the table with hook and loop adhesive side
a)
down. Pass the end of the cuff through the flat metal ring so that a loop
is formed. (Ignore this step if cuff is already prepared.)
Place the cuff over the left upper arm so that tube is closer to your lower arm.
b)
Lay the cuff on the arm so that the lower edge of the cuff lies
c)
approximately 2 to 3 cm above the elbow.
Important! The small white (Artery Mark) on the cuff must lie exactly
over the artery which runs down the inner side of the arm.
Tighten the cuff by pulling the end and close the cuff by affixing the
d)
hook and loop closure.
There should be little free space between the arm and the cuff. You
e)
should be able to fit 2 fingers between your arm and the cuff. Clothing must not restrict
the arm. Any piece of clothing which does, must be removed. Cuffs that don’t fit properly
result in false measurement values. Measure your arm circumference if you are not sure of
proper fit. Other size cuffs are available (Page 21).
Lay your arm on a table (palm upward) so the cuff is at the same height as your heart.
f)
Make sure the tube is not kinked.
Remain seated quietly for at least two minutes before you begin the measurement.
g)
Artery Mark