American Diagnostic Corporation (ADC) Proscope 2.5v - Manual (Page 3)

WARNING: The carrying cases provided with these devices are intended for long term storage or
transport between facilities or when shipping devices to and from ADC’s facility for repair or servicing.
Carry cases (including internal liners) can NOT be cleaned or disinfected and should be safely dis-
carded if contaminated. Do not carry the case into a contaminated environment.
WARNING: When replacing lamp, allow lamp to cool for five minutes before handling.
WARNING: When cleaning/disinfecting devices that have been used on patients, be sure to use ap-
propriate personal protective equipment and follow all safety precautions/warnings.
CAUTION: Consult the cleaning and disinfection instructions for each part for further information
about cleaning and disinfecting this product. Always remove batteries prior to cleaning or disinfecting
any device.
WARNING: No form of sterilization has been validated for this device or its corresponding compo-
nents and sterilization may compromise the safety and effectiveness of this device. (This includes
steam sterilization.)
WARNING: Use of any accessories or materials not indicated in the user's manual can degrade the
minimum safety of the equipment.
CAUTION: Federal law restricts this device to sale by or on the order of a physician or licensed health
care practitioner.
WARNING: During use metal components near instrument head can become warm. This is espe-
cially true if device is on for extended periods of time. Do not leave device on when not in use.
Otoscope
This instruction manual is for use with the Complete 2.5v Instrument Set (Item #5215), 2.5v Diagnos-
tic Set (Item #5210), 2.5v Otoscope (Item #5211 or 5211V), and all accessories and replacement
parts.
Battery Handle: (Item #5211-5) All instrument sets come equipped with a "C"
cell knurled chrome handle with rheostatic power switch.
Battery Replacement
Requires 2 "C" cell batteries. Remove the knurled cap at the base of the handle
by turning counterclockwise. Insert two fresh "C" cell batteries (not included)
with the positive polarity towards the instrument head. Replace battery compart-
ment cap by turning clockwise. (Fig. 1).
Removing and Attaching the Instrument Head
All instrument heads feature a bayonet style mount. To remove, push down
firmly and rotate counterclockwise. To engage, align slots on base of instrument
head with tabs on bayonet. Push head and twist clockwise until engaged.
(Fig. 2).
Turning the Instrument On
To illuminate, press the white power switch and rotate the rheostatic bezel
clockwise until desired lamp intensity is obtained (0 position is off, red 1 po-
sition is full power) Slide the switch in the opposite direction to turn off. (Fig.
3).
(Fig. 1)
(Fig. 2)
(Fig. 3)