American Diagnostic Corporation (ADC) 418 Adtemp - Manual (Page 3)

proper placement of the probe tip could result in a longer time for a reading.
Rectal use:
1. Commonly used for babies, young children or when it is difficult to take an oral or
underarm temperature.
2. After placing the probe cover on the thermometer, lubricate with a water-soluble jelly or
petroleum jelly .
3. Gently insert the probe tip no more than 1/2 inch or 1.3 cm into the rectum. Do not force the
tip into the rectum if resistance is encountered.
4. Dispose of the used probe cover and wash the thermometer as recommended.
5. The peak temperature should be reached in approximately 8 seconds.
Underarm (Axillary) use:
1. Wipe underarm with a dry towel.
2. Place probe tip in armpit and bring arm down against the body.
3. The probe should be pointing upward in the same direction as your body if possible.
4. The time required for an accurate underarm temperature may be 8 seconds or longer
depending on placement of the probe and closure of the arm against the body.
Operation of the °F - °C feature (How to change the measuring scale) From the “OFF” position,
hold down the “MULTI-FUNCTION” button for 5-sec. The thermometer will automatically change from
°F - °C or °C - °F. Release the button. After 3-sec. in one scale the °C or °F will flash, indicating
ready to measure.
Changing the battery:
When the “ ” appears in the lower right of the display, the battery is ex-
hausted and needs replacing. Make sure a battery of the same type is on
hand and proceed as follows: Remove battery cover. Use a small Phillips
screwdriver to remove battery compartment lid. Insert new equivalent battery
type (1.55v, LR41 or SR41). Ensure battery is correctly positioned with the
“+” facing up or towards the back of the unit. Carefully replace the battery
compartment lid, and then the battery cover. Properly dispose of the batter-
ies, keeping them from small children and heat.
Standards:
Complies with EN 12470-3:2000 and ASTEM E 1112-00
The manufacturer recommends a calibration check every 2 years.
How to care for this product:
• Use of probe covers is recommended to help avoid spreading germs, and to keep the thermometer
clean. The thermometer should be cleaned after use even when probe covers are used.
• Clean the thermometer tip and probe only using isopropyl alcohol or soap and water.
• Store the unit in the protective case while not in use.
• Do not store or keep in direct sunlight, or in high temperatures.
• Keep battery away from children.
• Do not open the thermometer except to replace the battery.
• Do not drop the thermometer, as this may ruin the unit.
• The manufacturer recommends verifying the accuracy by an authorized laboratory every
two years.
Battery
Cover
Screw