American Diagnostic Corporation (ADC) 423 Adtemp - Manual (Page 3)

HOW TO TAKE TEMPERATURE:
1. Place a probe cover carefully over the tip. Select oral, un-
derarm or rectal as your measurement site based on the individ-
ual requiring a temperature measurement (Figure 1).
2. Push the Multi-Function button located beside the dis-
play window. The thermometer will beep and the display will read: “188.8 ° . This is a func-
tion check indicating the unit is working properly. The last measured temperature will be
displayed for approximately 2 seconds. Next the thermometer will read L°F.(or L°C)
3. The °F or °C symbol will flash when the unit is ready to measure temperature. Please note that
the “ “ indicates a low battery. See instructions for replacing battery before measuring temperature.
Do not expect an accurate temperature reading if this low battery indicator is present. An “ERR” mes-
sage in the window indicates your unit is not functioning properly.
ORAL USE: (for children 4 years and older)
Do not drink hot or cold fluids, exercise or perform other activities that will raise or lower tempera- •
ture readings when compared to your normal, average temperature. The
mouth should remain closed up to 5 minutes before attempting a reading.
Place the probe tip well under the tongue as indicated by the •
“✔“, (Figure 2). Instruct children not to bite down on the probe.
The peak temperature should be reached in approximately 60 seconds. •
Opening the mouth or improper placement of the probe tip could result in
a longer time for a reading.
RECTAL USE:
Commonly used for babies, young children or when it is difficult to take an oral or un- •
derarm temperature.
After placing the probe cover on the thermometer, lubricate with a water-soluble jelly or •
petroleum jelly.
Gently insert the probe tip no more than 1/2 inch or 1.3 cm into the rectum. Do not force •
the tip into the rectum if resistance is encountered.
Dispose of the used probe cover and wash the thermometer as recommended. •
The peak temperature should be reached in approximately 40 seconds. •
UNDERARM (AXILLARY) USE:
Wipe underarm with a dry towel. •
Place probe tip in armpit and bring arm down against the body. (Figure 3). •
The probe should be pointing upward in the same direction as your body if possible. •
The time required for an accurate underarm temperature may be 90 seconds or longer de- •
pending on placement of the probe and closure of the arm against the body.
4. When peak temperature is reached, the °F or C° symbol will stop
flashing, and the thermometer will beep repeatedly. Please note: It is not
necessary to hear the beep to ensure the peak temperature has been
reached. When the °F or C° symbol stops flashing and the display reads a
consistent temperature, the peak temperature has been reached.
5. Read and record the temperature and time for reference. The
reading will automatically be stored in the memory.
6. Push the Multi-Function button to turn the unit off. This will prolong the battery life. If you
Fig. 1
F
M
Figure 2
Figure 3