American Diagnostic Corporation (ADC) 412 Adtemp User Manual

Page 3

Advertising
background image

you do not turn the unit off, it will shut off automatically in approximately 10 minutes.

Oral use: (for children 4 years and older)

1. Do not drink hot or cold fluids, exercise or perform other activities that will raise or lower

temperature readings when compared to your normal, average temperature.

The mouth should remain closed up to 5 minutes before attempting a read-

ing.

2. Place the probe tip well under the tongue as indicated (Figure 2).

3. Instruct children not to bite down on the probe.

4. The peak temperature should be reached in approximately 60 seconds. Opening the mouth

or improper placement of the probe tip could result in a longer time for a reading.

Rectal use:

1. Commonly used for babies, young children or when it is difficult to take an oral or under-

arm temperature.

2. After placing the probe cover on the thermometer, lubricate with a water-soluble jelly or pe-

troleum jelly.

3. Gently insert the probe tip no more than 1/2 inch or 1.3 cm into the rectum. Do not force the

tip into the rectum if resistance is encountered.

4. Dispose of the used probe cover and wash the thermometer as recommended.

5. The peak temperature should be reached in approximately 40 seconds.

Underarm (Axillary) use:

1. Wipe underarm with a dry towel.

2. Place probe tip in armpit and bring arm down against the body.

3. The probe should be pointing upward in the same direction as your body if possible.

4. The time required for an accurate underarm temperature may be 90 seconds or longer

depending on placement of the probe and closure of the arm against the body.

Operation of the °F - °C feature (How to change the measuring scale) From the “OFF” po-

sition, hold down the Multi-Function button for 5-sec. The thermometer will automatically

change from °F - °C or °C - °F. Release the button. You may toggle between °C +°F. After 3-

sec. in one scale the °C or °F will flash, indicating ready to measure.

Standards:

Complies with EN 12470-3:2000 and ASTEM E 1112-00

The manufacturer recommends a calibration check every 2-years.

How to care for this product:

• Use of probe covers is recommended to help avoid spreading germs,

and to keep the thermometer clean. The thermometer should be cleaned

after use even when probe covers are used.

• Clean the thermometer tip and probe only using isopropyl alcohol or

soap and water.

• Store the unit in the protective case while not in use.

• Do not store or keep in direct sunlight, or in high temperatures.

• Keep battery away from children.

• Do not open the thermometer.

Figure 2

Advertising