Antari SW-250 User Manual
Page 8
8
The receiver is tested and built in SW-250. Please do not try to remove it. The receiver responds to up to 5
different transmitters that are registered with the machine. The included transmitter has been registered with
the machine before shipment. It can be directly operated without any start-up setting.
Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For this
purpose, take off the housing cover and remove the used battery. Insert a fresh 12 V battery, and refit the
housing cover.
SC-2 (Optional): 25 ft. wired ON/OFF and volume remote controller with 4 pin XLR plug.
Red Switch – ON/OFF
To output, switch to ON. To stop, switch to OFF.
Volume Knob
Adjust the output volume from 10% to 100% by turning the knob.
Red LED Indicator
When the remote is connected to the machine, the red LED will be on.
Green LED Indicator
When red switch is switched to ON, the green LED will be on.