Antari M-1 - Manual (Page 4)

4
1. M-1 Mobile fogger
2. 12V – 2.3Ah rechargeable battery
3. Rechargeable battery charger
4. 500 cc bottle of Antari fog liquid
5. Briefcase sized Mobile Fogger flight case
․ If any equipment is missing contact your Antari dealer immediately.
․
Before beginning your initial setup of your Antari M-1 Mobile Fog Machine, make sure that
there is no evident damage caused by transportation.
․ In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt
to use it until after contacting your Antari dealer for assistance.
Setup
․ Remove all packing materials from the fog machine. Check that all foam and plastic padding
is removed, especially in the nozzle area.
․
Place fog machine on a flat surface and remove fog liquid tank cap.
․ Fill with Antari Fog Liquid (FLM-05) or dealer recommended high-quality water-based fog
fluid. Any other types of fluid can damage the unit. When filled, place cap back on liquid tank.
Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
․ Charge the battery. Plug the adaptor into a grounded electrical outlet. The green light on the
battery charger will light up when it is connected to the power supply. Then connect the
charging head to the battery. Please note the battery required 8 hours charging time on first
charge. Afterwards, the battery will be fully charged in approximately 2~3 hrs.
․ The charge will last between 10-12 minutes of constant fog output before needing to be
re-charged.
․ Plug the charged battery into the bottom of the M-1 Mobile Fogger with the label face up.
1. Lift-up the plate before inserting the battery.
2. Make sure the battery is inserted on the right position (see photo)